scott sent me some old cornies. a couple of them have plastic prvs that don't look so great. where do i get these thigns? it seems like it's a hole in the corny lid with a plastic nut on the inside holding the prv in.
corny keg with plastic PRV?
#1
Posted 11 April 2014 - 07:55 AM
#2
Posted 11 April 2014 - 07:57 AM
Pics?
#3
Posted 11 April 2014 - 08:00 AM
Like B? I think those may be discontinued
You can try and see if this fits the existing hole https://www.homebrew...bly_p_3502.html
I would just buy a new lid
https://www.homebrew...ded_p_1415.html
#4
Posted 11 April 2014 - 08:05 AM
yeup - B.
#5
Posted 11 April 2014 - 08:13 AM
yeup - B.
I feel like I just won the lottery!
#6
Posted 11 April 2014 - 08:18 AM
anyone have a super cheap source for lids? i have o-rings.
#7
Posted 11 April 2014 - 08:21 AM
anyone have a super cheap source for lids? i have o-rings.
I have looked for a while and the link I had above seems to be the best price. If you find anything better let me know!
Oh wait, This is what I should have posted before 13.25
https://www.cornykeg...p?prodid=700187
Edited by drez77, 11 April 2014 - 08:22 AM.
#8
Posted 11 April 2014 - 09:17 AM
I have looked for a while and the link I had above seems to be the best price. If you find anything better let me know!
Oh wait, This is what I should have posted before 13.25
cool thanks. looks to be a good price.
#9
Posted 11 April 2014 - 01:33 PM
another one of the kegs has a liquid out that i can't fit my QD onto. any ideas there? it's like i can't push it down enough to get it to lock in. if i hold it down i can get liquid to flow through but the moment i let go it pushes up a little.
#10
Posted 11 April 2014 - 10:36 PM
#11
Posted 12 April 2014 - 03:09 AM
Posts are different sizes, too buzzed to research but are you sure the right style is on the liquid?
it's a new keg to me (old keg). my brain is foggy right now but i guess it could be two gas posts on the keg. i didn't try putting the gas QD on what should be the liquid post yet.
#12
Posted 12 April 2014 - 07:18 AM
#13
Posted 12 April 2014 - 02:29 PM
Seal up the lid with the funky PRV and use a spunding valve
#14
Posted 14 April 2014 - 08:26 AM
Is there a horizontal notch on the area the wrench goes on one or both? The notch is the gas post style. Or are they swapped in general by chance?
Inquiring minds are wonder still?
#15
Posted 14 April 2014 - 10:08 AM
Inquiring minds are wonder still?
sorry - i meant to check. it was a rough weekend with one of the kids barfing all over my house. i felt bad for her. i have another keg where it can be tough as hell to get the liquid qd off sometimes and i wonder if i have the same issue going on there.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users