Well this has been years in the making but I'm determined to get it done this year. Time and money have put it off to the side but I've collected enough parts that I'm almost there. The first step was getting the brew room finished. I have 9x22 room in my poolhouse, which is a converted horse barn, that I will try and contain everything. I did the plumbing and electrical years ago as well digging out over a foot deep of dirt so I could hang joists and put in a rough cut pine floor. I'm doing the whole room in rough cut pine. The two end walls were already done and a few years ago I started doing another wall and got about 1/3 of the way up and ran out of wood. So in the mean time I have been using the room as is to store all my equipment and brew out of. Fast forward a few years till now and I finally finished all the walls in rough cut. Picked up a truck full last week and been working on it all this week. I got a few pics below as it is today. A few years ago a friend bought a foreclosed house and it came with a bunch of used stainless restaurant shelving. So I got all those for free. The sink was a craigslist find for $75. I'm going to go and start putting everything back in now.
This last pic is where the electric system will go. I got one more of those large stainless shelves that is 90" long that I'm going to cut out the center support then build a stand for. You can see the panel I put in and the 50amp plug for the control panel. The outlet up top with the dimmer switch will be for a exhaust fan.
Edited by matt6150, 29 January 2014 - 06:18 PM.